Lockers are shipped from the factory in welded form, to reduce installation cost.
The full height locker is the most common and is suitable for most needs.
The Double Tier locker can be used where space is a problem as it accommodates twice the number of people in the same space.
Our other type is the multiple person unit. This comes in two standard ways: lockerettes and archettes. Each compartment is 12" wide, 12" high, 18"deep. They are available with individual key locks or hasp attachments for padlocks.
Besides the above mentioned three, there are still other types available such as triple tier, or gym units made up of two double tiers and one full height or one lockerette and one full height or any other combination that will suit your requirements.
S/M Deluxe: This is our most popular line and the one we recommend for all uses. The straight clean lines combined with the ruggedness of no moving parts make it extremely hard to beat.
Finishing touches on locker installation, a full range of trim is available;
Our standard sizes for lockers are:
We will, however, custom fabricate to any size and with any extra equipment that you may require.
We will supply a host of optional equipment for our lockers.
Some
examples are:
STURDYMET WELDED LOCKERS SPECIFICATIONS:
Material:
Mild cold-rolled sheet steel free from surface imperfections.
Finish:
All parts to be thoroughly degreased, cleaned and given a bonding,
rust-retarding phosphate coat prior to an electrostatically applied coat
of quality enamel. Material then to be baked to produce a hard durable
finish. Colour L 124 grey.
Body: 26 ga.
All body parts to be designed to form rigid unit body construction.
End sides to have double bend at front edge to add stiffness.
Door Frame: 16 ga.
Door frame parts to be formed channel. Vertical members to have three
right angle bends to reduce the danger of exposed edges and add strength.
Horizontal members to be bent to channel shape. Parts to be electrically
welded together to form a strong, rigid unit.
Door:
To be fabricated of 20 gauge sheet and to be fully enclosed at rear
with a flush reinforcing sheet to form a closed box and made a rigid, whip-free
unit. Face of door to be flush with frame and free from protruding handles, locks,
louvers, etc.
Ventilation:
Slots to be cut in both upper and lower horizontal doorframe members
to allow air to flow freely in and out of entire locker from bottom to
top.
Latching:
Door to be held closed at centre by silent polypropylene friction
catch with no moving parts. There shall be two rubber bumpers mounted close
to top and bottom of frame to silence the closing of the door.
Locking:
Door to be locked with a hasp and padlock arrangement with no
moving parts. Padlock to be recessed into door handle. The lock shall be
recessed into door handle and, other than the lock itself, there shall
be no moving parts.
Handles:
Handles shall be one piece molded, sturdy polypropylene. Handle
to be recessed within the door except around edges which shall protrude
slightly (1 /1 6") to act as a protective bumper when door is opened
a full 180' against the adjacent door.
Hinges:
Shall not be less than 14 gauge 5 knuckle 21/2 inches high.
To be securely welded to frame and riveted to door. Hinge pin to be non-removable.
Doors 48" and larger to be hung on 3 hinges, others on 2 hinges.
Number Plates:
Shall be recessed into top of door handle. Figures shall be
not less than 3/8" high and non-erasable.
Interior Equipment:
All single tier lockers to be furnished with a hat shelf and
3 coat hooks. Multiple tier lockers do not have a shelf.
WebSite created by: gRIZaRT-
